Hello

We have installed the Cate maths flap.
Now I need help setting the time control.
I followed the instructions step by step and was able to set the time and our cat is finally recognised. My problem is the setting for the output or access lock....

If I want to lock the flap at the following times: Exit 6:00 a.m. - 6:00 p.m. how should I proceed? Do I have to activate both pillars (in and out) or just one and which one? I'm at a loss...
Well, I have now set the above-mentioned time and set the arrow "away from me" to outside but my cat cannot get in at any time. Thanks for your kind answers

Where do you get stuck?
4.3.1 Press the "TIMER" button for 5 seconds until the TIMER function indicator flashes in the display.
flashes in the display.
4.3.2 Press the "4 WAY" button repeatedly until the desired symbol for the access option to be selected appears: "ON & OFF".
access option to be selected appears: "ON & OFF", "ON ONLY", "OFF ONLY",
"LOCKED" OR "OFF" (SWITCHED OFF).
4.3.3 Press the "SET" button to save your setting.
4.3.4 The display shows the time with the minute symbol flashing.
Press the "+" key repeatedly until the current minute setting is displayed (e.g. 10 minutes).
is displayed (e.g. 10 if the current time is 12:10).
4.3.5 Press the SET button to save your setting.
4.3.6 The display will now show the time with the clock symbol flashing.
If you want to switch between the 24-hour clock and the 12-hour clock (AM/PM displays), press the "SET" key.
press the "TIMER" key.
4.3.7 Press the "+" key repeatedly until the current hour setting is displayed (e.g. 12 hours).
is displayed (e.g. 12, if the current time is 12:10).
4.3.8 Press the SET button to save your setting.
4.3.9 The display will now show "START" and the minutes will flash. Press the "+" key
until the current minute setting is displayed, (in the above example
"00"). Press the "SET" button to save your setting.
4.3.10 Then set the hours in the same way (19:00 in the example above).
4.3.11 The display shows the "FINISH" time. Set this in the same
same way as the "START" time. Press the "SET" button to save your setting.
setting is saved.
Once the timer is set, the TIMER function (fig. 1) is shown on the display.
is shown.
When the timed lock is active, the symbol selected in 4.3.2 for the
access option flashes slowly.